Driver Seat; Throttle And Choke Cables, Lever Bearings; Lubricating The Belt Adjuster; Checking The Engine's Oil Level - Husqvarna R 422Ts Operator's Manual

Driver seat

Fold up the seat.
Lubricate the lengthways adjustment runners with oilcan.
Throttle and choke cables, lever
bearings
• Remove the right side cover on the lever housing (3
screws) and open the engine cover.
• Lubricate the cables' free ends with the oilcan, even those
by the engine.
• Move the controls to the end points and lubricate again.
• Lubricate the joints, catches, and bearings for the cutting
unit's control levers with oil.
Replace the lever housing's side cover.

Lubricating the belt adjuster

Lubricate using a grease gun, 1 nipple from the right-hand
side under the engine's lower belt pulley, until grease is forced
out.
Use only good quality molybdenum disulphide grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
Lubrication

Checking the engine's oil level.

Check the oil level in the engine when the Rider stands
horizontal with the engine switched off. Do not check the oil
with the engine running.
Open the engine cover.
Loosen the dipstick, pull it up and wipe it off.
Now insert the dipstick again, without tightening it.
Pull the dipstick out again and read the oil level.
The oil level should be between the markings on the dipstick.
If the level is approaching the ADD mark, top up the oil to the
FULL mark on the dipstick.
The oil is topped up through the hole the dipstick sits in. Fill
the oil slowly.
Tighten the dipstick correctly before starting the engine. Start
and run the engine at idling speed for approx. 30 seconds.
Turn off the motor. Wait 30 seconds and check the oil level. If
necessary fill so that the oil comes up to the FULL mark on
the dipstick.
The following oil classes are recommended:
• API Service Class: SF, SG, SH and SJ
Choose an oil with viscosity according to the temperature
ranges in the figure:
Do not mix different types of oil.
Caution when using oils such as 5W-20, 10W-30 and 10W-40
the engine's oil consumption increases. If these oils must be
used, check the oil level frequently.
Replacing the engine oil
Open the engine cover.
The engine oil should be changed the first time after 8 hours
running time. It should then be changed after every 100 hours
of running time.
When operating with a heavy load or at high ambient
temperatures, replace every 50 hours.
!
WARNING! Engine oil can be very hot if it is
drained directly after stopping the engine.
Allow the engine to cool somewhat first.
– 33
English