Replacing The Hydraulic Pump's Drive Belt R 422 Ts Awd - Husqvarna R 422Ts Operator's Manual

6 Remove the cooling fan, it is held in place by a nut.
7 Remove the belt from the hydrostatic transmission pulley.
8 Pull the belt off of the engine's pulley and move it under
the engine belt pulleys.
9 Pull out the belt through the opening under the pivot
bearing and past the belt tensioner's disc.
Assembly
1 Pull the belt through the opening under the pivot bearing
and on the outside past the belt tensioner's disc.
2 Pull the belt under the engine belt pulleys and fit it on the
engine belt pulley.
3 Fit the belt on the hydrostatic transmission pulley.
4 Fit the cooling fan.
5 Check that the centre belt is fitted correctly on its front
pulley and fit the centre belt on the engine's pulley.
26 –
English
Maintenance
6 Fit the hose holder in the middle and the belt guide for the
centre belt.
Refit the spring (A).
Replacing the hydraulic pump's
drive belt R 422 Ts AWD
1 Remove the transmission cover.
2 Unhook the spring on the belt tensioner
3 Remove the belt guide for the centre belt.
4 Pull off the centre belt from the engine's pulley and pull out
the rear section.
A
B