Accessories - Heat Controller B-VCH12FC-1 Installation Manual

Heat Controller, Inc.
INSTALLATION INSTRUCTIONS
Tools needed for installation:
Level gauge
Screwdriver
Electric drill,Hole core drill
Flaring tool set
Torque wrench: 1.8kgf.m, 4.2kgf.m,
Spanner (half union)
Hexagonal wrench 1-1/2"(4mm)
Gas-leak detector
Accessories for mini-split high wall mount installation
Number
1
2
3
5
6
7
8
9
FLARE NUT ADAPTER
10
3/8" FFL to ½" flare nut provided with some
indoor models as required to make with the
outdoor units line set.
11
Note: Except for the above parts provided, any other parts needed during installation you must
purchase.
Note: The seal and drain connector elbow are only available
with some models. Your particular product may not come with
these parts factory supplied, however they can be purchased
locally. All other parts required for installation must be purchased
separately/locally including but not limited to tools, line sets,
insulation etc.
Ø1/4" (65 mm)
Name of Accessories
Installation Plate
Dry wall anchors
Self-tapping Screw A ST3.9X25
Remote controller
Self-tapping Screw B ST2.9X10
Remote controller holder
Seal (outdoor heat pumps only)
Drain Joint
(outdoor heat pumps only)
FERRILE COR FILTER (clip-on)
optionally installed on the communication
cable between the indoor and outdoor unit to
reduce EMI RFI noise.
VMH SerieS
Optional
parts
8
4
9
Vacuum pump
Gauge manifold
Users manual
Thermometer
Multimeter
Pipe cutter
Measuring tape
Q ty/one unit ¡
1 (
high wall mount only
5-8
(depending on models)
5-8
(depending on models)
1
2
1
1
1
1
(on some models)
Optional
9
Installation Manual
)