Vector VEC090 Owner's Manual & Warranty Information
  1. Manuals
  2. Brands
  3. Vector Manuals
  4. Battery Charger
  5. VEC090
  6. Owner's manual & warranty information
Vector VEC090 Owner's Manual & Warranty Information

Vector VEC090 Owner's Manual & Warranty Information

Automatic battery charger
Hide thumbs
Table of Contents

Advertisement

Quick Links

Advertisement

Table of Contents
loading

Related Manuals for Vector VEC090

Summary of Contents for Vector VEC090

  • Page 2 GROUNDING PIN (A) METAL SCREW ROUNDING MEANS USE OF AN ADAPTER IS NOT ALLOWED IN CANADA. IF A GROUNDING TYPE RECEPTACLE IS NOT AVAILABLE, DO NOT USE THIS APPLIANCE UNTIL THE PROPER OUTLET IS INSTALLED BY A QUALIFIED ELECTRICIAN. VEC090...

  • Page 3: Preparing To Charge

    When disconnecting charger, disconnect AC cord, remove clip from vehicle chassis, and then remove clip from battery terminal. h. See operating instructions for length of charge information. i. Do not charge the battery while the engine is operating. VEC090...

  • Page 4: Introduction And Features

    INTRODUCTION AND FEATURES Thank you for selecting the Vector Model VEC090 2/10/20 Amp 12 volt Smart Battery Charger, Check with Alternator Voltage and Battery Recondition modes. With proper care and use, will give you years of dependable service. This model battery charger has a high charge rate of up to 35 amps, and low charge rate of up to 2 amps.

  • Page 7: Charge Rate Selection

    NOTE: If there is any problem connecting the charger clamps to the battery terminals, contact the NOTE: Vector Technical Support Department toll-free at (866) 584-5504 for assistance. d) Plug battery charger power cord into grounded AC power outlet and refer to Appendix A at the end of this document for approximate charging times.

  • Page 8: Charging Times

    CHARGING TIMES CHARGING TIMES The VEC090 is a fully automatic battery charger. It automatically adjusts the charge rate as the battery becomes charged and stops charging when the battery is fully charged. if you require some estimate of the time takes to charge a battery refer to Appendix A for these details.

  • Page 9: Care And Maintenance

    CARE AND MAINTENANCE CARE AND MAINTENANCE With only minimal maintenance, this Vector 2/10/20A Smart Battery Charger will deliver years of dependable service. Follow these simple steps to maintain the charger in optimum condition: ! After each use, clean the battery charger clamps be sure to remove any battery fluid that will cause corrosion of the copper clamps.
  • Page 10 Try charging another battery, if the FAULT LED does not light, then one of the above problems exists. Charger will not charge and the fan will not operate if there is a fault. Call Vector Technical Support at (866) 584.5504...
  • Page 11 APPENDIX A APPENDIX A CHARGING TIMES CHARGING TIMES — To calculate the approximate charging time required to fully charge a battery, is necessary to determine the specific gravity (or, percent of battery charge) using a hydrometer. Use this technique if battery vent caps can be removed.
  • Page 12 30 days but less than five year from the purchase date, Vector Manufacturing will repair the unit or, at its option, replace it free of charge.
  • Page 13 WARRANTY IS NON-TRANSFERABLE AND NON-REFUNDABLE. VECO9O VECO9O 12 12...

Table of Contents