Vector VEC1087 A Owner's Manual & Warranty Information
  1. Manuals
  2. Brands
  3. Vector Manuals
  4. Battery Charger
  5. VEC1087 A
  6. Owner's manual & warranty information
Vector VEC1087 A Owner's Manual & Warranty Information

Vector VEC1087 A Owner's Manual & Warranty Information

Smart automatic battery charger 12 volt 2/6/10 amp charge rates
Hide thumbs
Table of Contents

Advertisement

Quick Links

12 VOLT 2/6/10 AMP CHARGE RATES
OWNER'S MANUAL & WARRANTY INFORMATION
• IMPORTANT SAFETY INSTRUCTIONS •
WARNING – RISK OF EXPLOSIVE GASES
1. WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES
GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS
REASON, IT IS OF UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR
CHARGER, YOU READ THIS MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY.
2. To reduce risk of battery explosion, follow these instructions and those published by the battery
manufacturer and manufacturer of any equipment you intend to use in vicinity of battery. Review
cautionary markings on these products and on engine.
GENERAL BATTERY SAFETY
1. Use this charger for charging a 12 VOLT LEAD-ACID battery only. It is not intended to supply power to a low voltage
electrical system other than in automotive applications. Do not use this battery charger for other types of batteries,
these may burst and cause injury to persons and damage to property.
2. Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire,
electric shock, or injury to persons.
3. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger.
4. An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result
in a risk of fire and electric shock.
If extension cord must be used, make sure:
a. That pins on plug of extension cord are the same number, size, and shape as those of plug on charger.
b. That extension cord is properly wired and in good electrical condition; and
c. That wire size is AWG #14 (14 gauge) to 100 feet and AWG #12 for distances over 100 feet.
5. Do not operate charger with damaged cord or plug - replace immediately.
6. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take
it to a qualified service technician.
7. Do not disassemble charger; take it to a qualified service technician when service or repair is required. Incorrect
reassembly may result in a risk of electric shock or fire.
8. To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. Turning
off controls will not reduce this risk.
9. Do not expose charger to rain, snow or use when wet.
10. Never charge a frozen battery.
SAVE THESE INSTRUCTIONS:
This manual contains important safety and operating instructions for battery charger Model VEC1087 AA
SMART AUTOMATIC

BATTERY CHARGER

This device complies with Part 15 of the FCC Rules.
VEC1087 A

Advertisement

Table of Contents
loading

Related Manuals for Vector VEC1087 A

Summary of Contents for Vector VEC1087 A

  • Page 1: Battery Charger

    VEC1087 A SMART AUTOMATIC BATTERY CHARGER 12 VOLT 2/6/10 AMP CHARGE RATES OWNER’S MANUAL & WARRANTY INFORMATION • IMPORTANT SAFETY INSTRUCTIONS • WARNING – RISK OF EXPLOSIVE GASES 1. WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS REASON, IT IS OF UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR CHARGER, YOU READ THIS MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY.

  • Page 2: Ground And Ac Power Cord Connection

    GROUNDING PIN (A) METAL SCREW GROUNDING MEANS USE OF AN ADAPTER IS NOT ALLOWED IN CANADA. IF A GROUNDING TYPE RECEPTACLE IS NOT AVAILABLE, DO NOT USE THIS APPLIANCE UNTIL THE PROPER OUTLET IS INSTALLED BY A QUALIFIED ELECTRICIAN. VEC1087 A REV101103...

  • Page 3: Preparing To Charge

    When disconnecting charger, turn switches to off, disconnect AC cord, remove clamp from vehicle chassis, and then remove clamp from battery terminal. h. See operating instructions for length of charge information. i. Do not charge the battery while the engine is operating. VEC1087 A REV101103...

  • Page 4: Introduction And Features

    INTRODUCTION AND FEATURES Thank you for selecting the Vector® Model VEC1087 A, 2/6/10 Amp 12 volt Smart Battery Charger. With proper care and use, it will give you years of dependable service. This model battery charger has a high charge rate of up to 10 amps, and low charge rate of up to 2 amps.

  • Page 5: Control Panel

    • Small 12-volt DC batteries such as those used in motorcycles, garden tractors, ATVs, jet skis, and snowmobiles can be damaged by high charge rates. ALWAYS select the 2 Amp setting to charge this type of battery. For slower charging time on larger batteries, select the 2 Amp setting. VEC1087 A REV101103...

  • Page 6: Charging If Battery Is Installed In Vehicle

    FIGURE 3 WARNINGS: • THERE ARE NO USER-SERVICEABLE PARTS IN THIS UNIT. • DO NOT OPEN THE UNIT. IT MUST BE RETURNED TO VECTOR FOR PROFESSIONAL TESTING AND REPAIR. OPENING THE UNIT WILL VOID THE MANUFACTURER'S WARRANTY. WARNING: If battery size is not known, charge at the 2 Amp rate. DO NOT overcharge batteries.

  • Page 7: Charging If Battery Is Outside Of Vehicle

    CHARGING TIMES The VEC1087 A, fully automatic battery charger will automatically adjust the charge rate as the battery charges and stops charging when the battery is fully charged. If you require some estimate of the time it takes to charge a battery refer to Appendix A (page 9) for these details.

  • Page 8: Troubleshooting

    Try charging another battery, if the FAULT LED does not light, then one of the above problems exists with the initial battery. Charger will not charge and the fan will not operate if there is a fault. Call Vector Technical Support toll free: (866) 584-5504.

  • Page 9: Charging Times

    Answer: approximately 8 hours. Always round up charge time by 10% to ensure full charge. In most cases, battery charge times will vary depending on age and condition of battery. Smaller batteries should be charged at the lower rate (2 Amps) and add an extra hour to charge time. VEC1087 A REV101103...

Table of Contents