Troubleshooting - D-Link DSL-2500U User Manual

Appendix B - Networking Basics
This chapter provides solutions to problems that might occur during the installation and operation of the DSL-2500U . Read the following
descriptions if you are having problems. (The examples below are illustrated in Windows® XP. If you have a different operating system, the
screenshots on your computer will look similar to the following examples.)
1. How do I configure my DSL-2500U Router without the CD-ROM?
• Connect your PC to the Router using an Ethernet cable.
• Open a web browser and enter the address
• The default username is 'admin' and the default password is 'admin'.
• If you have changed the password and cannot remember it, you will need to reset the Router to the factory default setting (see question 2),
which will set the password back to 'admin'.
Note:
Please refer to next section Network Basics to check your PC's IP configuration if you can't see the login window.
2. How do I reset my Router to the factory default settings?
• Ensure the Router is powered on.
• Press and hold the reset button on the back of the device for approximately 5 to 8 seconds.
• This process would take about 1~2 minutes to complete.
Note:
Resetting the Router to the factory default settings will erase the current configuration settings. To reconfigure your settings, log into the Router as
outlined in question 1, and then run the Quick Setup wizard.
3. What can I do if my Router is not working correctly?
There are a few quick steps you can take to try and resolve any issues:
• Follow the directions in question 2 to reset the Router.
• Check that all the cables are firmly connected at both ends.
• Check the LEDs on the front of the Router. The Power indicator should be on, the Status indicator should flash, and the DSL and LAN
indicators should be on as well.
D-Link DSL-2500U User Manual

Troubleshooting

http://192.168.1.1
53