Lenovo ThinkServer 1045 Installation And User Manual page 72

CAUTION:
The heat sink might be very hot. Turn off the server and wait three to five minutes to let the server
cool before removing the server cover.
To remove the heat sink, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See "Removing the server cover" on page 19.
3. Remove the microprocessor fan duct. See Removing the microprocessor fan duct.
4. Loosen the four screws that secure the heat sink and then carefully lift the heat sink out of the chassis.
Figure 54. Removing the heat sink
1 4
- Screws
5
Air flow
6
The front of the chassis
5. If you are instructed to return the heat sink, follow all packaging instructions and use any packaging
materials that are supplied to you for shipping.
6. To install the heat sink, see Installing the heat sink.
62
ThinkServer Installation and User Guide