Lenovo ThinkServer 1045 Installation And User Manual page 58
Hide thumbs
Also See for ThinkServer 1045:
- Hardware maintenance manual (166 pages) ,
- Benutzerhandbuch (156 pages) ,
- Manual d'utilisation (152 pages)
Table of Contents
Advertisement
c. Hold the battery card assembly with the battery side up and the J5 board-to-board connector
lining up with the J10 BBU connector
assembly onto the RAID controller so that the two connectors are firmly joined. Then, secure the
battery card assembly to the RAID controller with the three screws and the standoffs that come
with the battery card assembly accessory kit.
Figure 39. Installing the battery card assembly onto the RAID controller
1
J10 BBU connector
6. Connect one end of the mini SAS signal cable to the RAID controller.
Note: Use the two 400 mm (15.75 inches) mini SAS signal cables.
Figure 40. Connecting the mini SAS signal cables to the RAID controller
1
Ports 0-3
2
Ports 4-7
a. For one mini SAS signal cable, connect the end to the ports 0-3 on the RAID controller.
b. For the other mini SAS signal cable, connect the end to the ports 4-7 on the RAID controller.
7. Install the RAID controller into an appropriate PCI card slot on the riser card assembly. Then, install
the screw to secure the RAID controller in place.
48
ThinkServer Installation and User Guide
1
on the RAID controller. Carefully press the battery card
Advertisement
Table of Contents
