Usb - Intel DN2800MT Technical Product Specification

1.6.3

USB

The board supports up to ten USB ports. The port arrangement is as follows:
Four front panel ports (via two internal headers; one header supports an Intel
Z-U130 USB Solid-State Drive (or compatible device))
Two ports are implemented with stacked back panel connectors (black)
Two high-current/fast-charging ports are implemented through stacked back panel
connectors (yellow)
One port implemented in the PCI Express Half–Mini Card slot
One port implemented in the PCI Express Full-/Half-Mini Card slot
The USB controller on the Intel NM10 Express Chipset provides a direct logical
connection to the USB ports on the back panel as well as on the PCI Express Mini Card
slots, and an indirect connection (through onboard USB hub) to the internal USB
headers. All ten USB ports are high-speed, full-speed, and low-speed capable.
NOTE
Computer systems that have an unshielded cable attached to a USB port may not
meet FCC Class B requirements, even if no device is attached to the cable. Use a
shielded cable that meets the requirements for full-speed devices.
For information about
The location of the USB connectors on the back panel
The location of the front panel USB headers
Product Description
Refer to
Figure 12, page 46
Figure 13, page 47
®
27