36
C
5: R
HAPTER
OUTER
Home
LAN Setup
C
ONFIGURATION
Figure 20 Home Screen
There are two buttons on this screen - Connect and Disconnect. These
buttons allow you to manually connect or disconnect your router from
your ISP's service.
Your Router is equipped with a DHCP server that will automatically assign
IP addresses to each computer on your network. The factory default
settings for the DHCP server will work in most any application. If you
need to make changes to the settings, you can do so.
The changes that you can make are :
Change the Internal IP address of the Router. The default =
192.168.2.1
Change the Subnet Mask. The default = 255.255.255.0
Enable/Disable the DHCP Server Function. Default = ON (Enabled)
Specify the Starting and Ending IP Pool Address. Default = Starting: 2 /
Ending: 100