Controls And Function - Mitsubishi Daiya FDTJ28HKXE2 User Manual

FDFL Series
Remote control
Controls the operation of air conditioner.
Cool or warm air is blown through
Suction grille
Inhales air in the room.
Air filter
Removes dust or dirt from inhaled air.
Outdoor Unit
G FDCJ140HKXE2B
G FDCP140HKXE2B
Air outlet
Air inlet
Provided on the back of the unit.
Air outlet
Air inlet
Provided on the back of the unit.
4
FDFU Series
Discharge grille
the louver.
G FDCJ224HKXE2B, 280HKXE2B
G FDCP224HKXE2B, 280HKXE2B
G FDC2001HKXRE2, 2501HKXRE2
G FDCP2001HKXRE2, 2501HKXRE2

CONTROLS AND FUNCTION

The illustration below shows the status that the cover is open. The liquid crystal display area indicates the full
contents of display for explanation.
Pull the knob towards you to open the cover downward.
"AUTO SWING" switch are not equipped for FDR, FDUM, FDFL, FDFU series.
Filter sign
When this display is indicated,
clean the air filter.
See page 7 and 9.
Remote display
This display is indicated when the unit is controlled by
the normal individual remote controller.
(The indication remains intact while the air-conditioner
is stopped, too.)
Center display
This display is indicated when the unit
is controlled by the center console that
is sold separately.
Timer operation display
This display indicates the content of
timer operation.
(The indication remains intact while
the air-conditioner is stopped, too.)
CENTER REMOTE
Time display/
PROGRAMTIMER
SE T TEMP
indoor unit No. display
ON OFF E
AM
PM
Setting temperature display
This display indicates the setting
temperature.
FILTER
TIMER
RESET
CHECK SET
Blow rate display
The fan speed set is displayed.
Filter reset switch
This switch resets (erases) the filter sign
display.
(Press this switch after the cleaning of
filter has been finished.)
Cover
Check switch
This switch is used for service.
Timer switch
This switch is used to select the content of timer
operation. See page 5 and 6.
Setting switch
This switch is used to set the timer time.
See page 5 and 6.
CAUTION
Operation mode display
The selected operation mode is
indicated.
Preparation of heating
(HOT KEEP) display
See page 9.
Operation/check indication lamp
During normal operation: Green
lamp is lit.
When an error occurred: Red lamp
flickers.
AUTODRYCOOLFANHOT KEEP I
ON/OFF switch
FAN
This switch performs run/stop of the
HI
Outdoor No.
MED air-conditioner. Press switch once to
C O
LO C O
"run" and press it again to "stop".
(The switch can be operated without
opening the cover.)
FAN
MODE
SPEED
TEMP
TIME
AUTO
SWING
Return air temperature display
The temperature of return air is
indicated.
N O T E
The indicated temperature value
may be different from the indication
of thermometer, etc. but this is not
abnormal.
Auto swing display
The state of the swing flap is
displayed.
Mode switch
This switch makes selection of the
operation mode.
Auto swing switch
Activates and stops the swing flap.
See page 6.
Blow rate switch
The fan speed is switched.
Temperature setting/time setting switch
This switch is used to set the room
temperature and the timer time.
See page 5.