Display Data Channel (Ddc); Installation - Toshiba TekBright User Manual

User's Manual

Display Data Channel (DDC)

The monitor supports DDC2B standard, which allows Plug and Play and
makes your monitor installation easier. It requires that your computer
system also support DDC protocol. DDC (Display Data Channel) is a
communication protocol through which the monitor automatically informs
the host system about its capabilities, for example, supported resolutions
and corresponding timing.

Installation

To install the monitor to your host system, please follow the steps as given
below:
1. Connect the Video Cable
■
D-SUB Cable (VGA cable)
■
■
■
DVI Cable
■
■
2. Connect the power cord
Connect the power cord to the monitor, then to a properly grounded AC
outlet.
3. Connect the Audio Cable.
4. Turn the monitor ON.
5. Then turn ON the computer. It is very important to follow this sequence.
6. If the monitor does not function properly, please refer to the
troubleshooting section to diagnose the problem.
AC Inlet
12
Make sure both the monitor and computer are turned OFF.
Connect the VGA video cable to both the monitor and the computer.
Make sure both the monitor and computer are turned OFF.
Connect the DVI video cable to both the monitor and the computer.
Cable lock slot
D-SUB port
DVI-D port
Audio port