Preset Modes; Power Saving - Toshiba TekBright User Manual

Preset modes

Your monitor has default setting modes that are most commonly used (see
the table below). For optimum adjustment, perform the Auto Setup under
Windows "Full Screen" pattern. The monitor is capable of storing up to 9
user modes. The only condition to store as a user mode is the new display
information must have 1 KHz difference for horizontal frequency or 1 Hz for
vertical frequency or the sync signal polarities are different from the default
modes.
Mode
1
2
3
4
5
6
7
8
9
10
11

Power Saving

The monitor will go into "Power Saving" mode by the control signal from the
display controller and the power LED will glow amber.
Power saving mode
The monitor will stay in power saving mode until a control signal has been
detected or the keyboard or mouse is activated. The recovery time from
power saving mode to ON is about 5 seconds.
Resolution
VGA 720 x 400
VGA 640 x 480
VESA 640 x 480
VESA 800 x 600
VESA 800 x 600
VESA 1024 x 768
VESA 1024 x 768
MAC 1152 x 864
SXGA 1280 x 1024 60 Hz
SXGA 1280 x 1024 75 Hz
WSXGA+ 1680 x 1050 60 Hz
State
ON
H.Freq.
(KHz)
70 Hz 31.47
60 Hz 31.47
75 Hz 37.50
60 Hz 37.88
75 Hz 46.88
60 Hz 48.36
75 Hz 60.02
75 Hz 67.5
64
80
65.3
Power
Consumption
Normal
<2 W
User's Manual
Polarity
Band Width
(MHz)
H
28.322 -
25.175 -
31.5 -
40 +
49.5 +
65 -
78.75 +
108 +
108 +
135 +
146.25 -
LED Light
Green
Amber
V
+
-
-
+
+
-
+
+
+
+
+
11