Kodak i5000 Series Installation And Using Manual page 2

5. After inserting the manual feed shelf, install the
side guides. Align the holes on the manual
feed shelf with the pegs on the left side guide
as shown.
6. Insert the right side guide in the same manner
as in Step 5.
7. Open the locking tabs on the side guides of the
manual feed shelf.
8. Adjust the side guide to the desired position by
sliding them in or out to accommodate the size
of the document(s) you are scanning.
9. Close the locking tabs on the side guides of the
manual feed shelf.
10. Open your scanning application and set the
scanner's input elevator in the highest position
(i.e., Document Feeder).
11. Scan the document(s) in single-sheet or hand-
held position.
Removing the manual feed shelf
1. Lower the input elevator to the lowest position.
2. Remove the manual feed shelf side guides.
3. Open the scanner cover.
4. Remove the manual feed shelf.
© Kodak, 2010. All rights reserved.
Eastman Kodak Company
343 State Street
Rochester, NY 14650 U.S.A.
TM: Kodak