Kenwood Nexedge NX-230EX Instruction Manual page 28

selected ID in all fl eets (Supervisor call).
STATUS MESSAGE
You can send and receive 2-digit Status messages which may
be decided in your talk group. Messages can contain up to 16
alphanumeric characters. Status messages range from 10 to 99
(80 ~ 99 are reserved for special messages).
A maximum of 15 received messages (combined status
messages and short messages) can be stored in the stack
memory of your transceiver.
Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as [Status] to enter Status
mode (proceed to step 5) or [Selcall + Status] to enter
Selcall mode (proceed to step 3).
3 Press
• If Manual Dialing is enabled, you can enter a station ID
by using the Keypad, or by using
press
Repeat this process until the entire ID is entered.
4 Press
5 Press
• If Manual Dialing is enabled, you can enter a status ID by
using the Keypad, or by using
above).
6 Press the PTT switch or Side 2 key to initiate the call.
• "<COMPLETE>" appears on the display when the status
has been successfully transmitted.
18
/ to select the station you want to call.
/ , cycle through the digits to select a digit, then
to set the digit and move the cursor to the right.
to enter Status mode.
/ to select the status you want to transmit.
/ When using
/ (refer to step 3,