Table of Contents
Advertisement
2
INSTALLATION
2-1.TURNING ON/OFF THE PROJECTOR
2-1-1.STARTING UP THE PROJECTOR
1.
Ensure that the supplied power cord is
securely connected at the AC inlet of the
projector (Drawing 8) and power outlet.
2.
Remove the lens cap.
3.
Turn on the power switch. Ensure the "Power"
indicator on the Control Panel is flashing blue,
indicating the projector is in Standby mode.
4.
Turn on the Lamp by pressing the "Power"
button on the Control Panel or the "Power"
button on the Remote Control. Ensure that
the "Power" indicator is continuous blue,
indicating the projector is on.
5.
The start-up screen appears on the screen
and starts to count down for 10 seconds.
6.
The projector will
detect the input source
automatically.
7.
Play your source
Power switch
device.
DRAWING 8
2-1-2.SHUTTING DOWN THE
PROJECTOR
1.
Turn off your source device first.
2.
Press the "Power" button on the Control
Panel or press the "Power" button on
Remote Control, and a message "Power off
the projector?" will show on the screen.
3.
Promptly press the "Power" button again to
confirm turning off the projector. Otherwise
the message will disappear after 5 seconds.
4.
The projector will begin a 100 seconds
cooling down phase.
Note: Please don't turn off the power switch
or disconnect the power cord during the
cooling down period.
5.
When the projector has cooled down, the
"Power" indicator on the Control Panel will be
flashing blue, indicating the projector is in
Standby mode.
6.
Turn off the power switch. Replace the lens
cap.
7.
Disconnect the power cord from the AC inlet
of the projector and power outlet.
2-1-3.LED INDICATION STATUS
Condition
1. Standby
2. Operating
3. Cooling
4. Boost Mode in Use
5. Fan Failure
AC inlet
6. Overheating
7. Overheating While Starting
8. Lamp Cover Open
Power
Thermal
Normal/Boost
Indicator
Indicator
Flashing
-
Blue
(1sec interval)
Blue
-
Blue
-
Blue
-
Red
Blue
(0.5sec interval)
Blue
Red
(0.5sec interval)
Blue
Red
(0.5sec interval)
-
Red
Note
Indicator
Green
Waiting for power on
-
Normal operation
-
Cool lamp down for
100 sec
Green
Boost mode is being
used
-
Fan failure.
There is a warning
message displayed
on the screen then the
projector will turn
itself off.
-
Overheating
in the projector:
There is a warning
message displayed
on the screen then the
projector will power
itself off.
-
The system will cool
itself down for 8 sec
automatically.
-
If the lamp cover is not
properly seated after
changing a new lamp,
the power can't be
turned on.
7
Advertisement
Table of Contents
