Advertisement
14.
15.
16.
17.
18.
19.
20.
Ampere rating
(on nameplate)
Ext. Cable Length
25 Ft.
50 Ft.
75 Ft.
100 Ft.
150 Ft.
REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to
see that keys and adjusting wrenches are removed from tool before turning
it on.
AVOID UNINTENTIONAL STARTING. Don't carry plugged-in tool with finger
on switch. Be sure switch is OFF when plugging in.
OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only
extension cords intended for use outdoors and so marked.
STAY ALERT. Watch what you are doing, use common sense. Don't operate
tool when you are tired.
CHECK DAMAGED PARTS. Before further use of the tool, a guard or other
part that is damaged should be carefully checked to determine that
it
will
operate properly and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting, and
any other conditions that may affect its operation. A guard or other part
that is damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in this instruction
manual. Have defective switches replaced by authorized service center. Don't
use tool if switch does not turn
it
on and off.
GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded
surfaces. For example; pipes, radiators, ranges, refrigerator enclosures.
REPLACEMENT PARTS. When servicing, use only identical replacement parts.
0 -
2.10
-
3.50
-
5.10
-
7.10
-
12.10
-
2.00
3.40
5.00
7.00
12.00
16.00
Wire Size (American Wire Gauge)
18
18
18
18
16
14
18
18
18
16
14
12
18
18
16
14
12
10
18
16
14
12
1 0
~
1 6
14
12
12
-
-
VOLTAGE WARNING: Before connecting the tool to a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool. A power source with voltage greater than that specified
for the tool can result in SERIOUS INJURY to the user
-
as well as damage to
the tool. If in doubt, DO NOT PLUG IN THE TOOL. Using a power source with
voltage less than the nameplate rating is harmful to the motor.
Use Of Extension Cord
If the extension cord is intended to be used outdoors, the cord shall be marked
with the suffix W-A following the cord type designation, for example
-
SJTW-
A, t o indicate
it
is acceptable for outdoor use. Use an extension cord heavy
enough to carry the current the tool will draw. Undersize cord will cause a drop
in line voltage resulting in loss of power and over-heating. Make sure the exten-
sion cord is in good condition before using. Use the table below t o determine
the proper wire size required in the extension cord.
Advertisement
