Advertisement
Removing or installing guide plate
To remove the guide plate, carefully un-
hook the end of the spring from the saw
base by pushing forward and raising it.
Then remove the guide plate by sliding it
backward.
To install the guide plate, follow the
re-
moval procedures in reverse.
I
Fig. 15
CAUTION :
Never stretch the spring more than 350 mm (13-25/32") long. The spring may come off
the guide plate unexpectedly, resulting an injury to you.
Guide rule (Rip fence)
The handy guide rule allows you t o do ac-
curate straight cuts parallel with a straight
edge of the workpiece. To install the guide
rule, first remove the guide plate from the
tool. Then simply slide the guide rule up
snugly against the side of the workpiece
and secure it i n position for the desired
cut with the nut on the front of the base.
It also makes repeated cuts of uniform
width possible.
h
Fig. 16
10
Advertisement
