Using Your Humidifier - Hunter 33520 Owner's Manual

Initial Setup:
1. Remove the plastic bag covering from the humidifier.
2. Unravel and straighten the cord before use.
3. Remove the Water Tank from the Base by pulling straight up
on Tank Handle. Figure 1.
4. Turn the Water Tank upside down and twist the Water Tank
Cap counter-clockwise to remove. Figure 2.
5. Fill the unit with clean, cool tap water.
Warning:
Never fill the humidifier with hot water.
6. Place the Water Tank Cap back on the Water Tank and turn
it clockwise until secure.
7. Place the Water Tank back into the Base, making sure it is
seated securely.
Note: Failure to ensure the Water Tank is seated correctly
could cause the unit to leak water.
8. Plug the humidifier into a wall outlet and start the unit.
Operation:
1. To turn the humidifier on, turn the power knob clockwise
until you feel the knob click. At this time, the unit should be on.
Adjust the amount of mist/vapor the unit outputs by turning the
mist adjust knob clockwise. To turn the unit off, turn the power
knob counter-clockwise until it clicks. Figure 3.
2. When the unit is out of water, the Refill Tank light will
illuminate.
3. Refilling the Water Tank and placing it securely back on the
Base will turn the Refill Tank light off.
Function and Features:
Power Knob- turns unit off and on. Figure 3.
Humidity - should be illuminated when unit is running.
Refill Tank - When the unit is low on water the Refill Tank
indicator on the front panel will light up.
Heat Mist - Select warm humidification by pressing in the
Heat Mist button. The Heat Light will illuminate to indicate
your selection. Warm humidification uses more power but
will humidify your room quicker.
Mist Adjust - Turn dial to adjust the vapor/mist output.
Turn clockwise to increase the output.
360° Spout Rotation - The spout can rotate a full 360°.
Figure 1.
4

Using Your Humidifier

44124-01 • 08/07/2012
Water
Spout
Tank
Handle
Water
Tank
Figure 1
Figure 2
Refill
Power
Tank
Figure 3
Humidity Heat
Mist Heat
Adjust Mist
Figure 4