Operating Your Humidifier - Hunter 37205 Manual

Functional Buttons
There are 6 buttons to control the functions of
the humidifier. You will hear a confirmation 'beep'
when a button is pressed.
1. PoWeR – Press the POWER button
to set the humidifier to HI. Press the
POWER button again to turn the unit
OFF.
a. When initially turned ON after being
plugged in, the humidifier will 'beep'
and all icons on the screen will be
temporarily illuminated. After a few
seconds, the LCD icons will turn OFF,
and the unit will be in standby mode
with the backlight OFF.
b. Pressing POWER once will set the unit
to HI and turn the backlight ON. The
LCD screen will display the Continue
message ("CO %") which means the
unit will be continuously on HI until
set otherwise. After a few seconds, the
current room humidity and the ROOM
message will be displayed.
c. If the unit is plugged in and has been
turned ON once, turning the unit OFF
and back ON will display the Relative
Humidity (RH) value last used.
42999-01 06/07/2006
42999_EngFr_WM Dig Humid.indd 5

operating Your humidifier

UP
DOWN
SETTING
LIGHT
RESET
POWER
d. When the unit is ON, all backlights will
remain ON.
. SeTTInG – The humidifier has two
settings: HI and LOW. Press the SETTING
button and the unit will loop settings
(HI-LOW-HI) while the respective icon is
illuminated.
3. uP – Each time the UP button is
pressed, the RH value will increase
by 5 %.
doWn – Each time the DOWN button
4.
is pressed, the RH value will decrease
by 5 %.
5. ReSeT – When the water level is too
low, the unit will turn itself OFF. Pressing
the RESET button will reactivate the unit
after you have refilled the tank.
6. nITe GLo™ – Press the NITE GLO
button to turn the blue night light
ON or OFF.
5
© 2006 Hunter Fan Company
6/7/06 1:25:22 PM