Installation instructions
US
10
CA
Before placing food in the fresh food or freezer compartments
Remove all packaging. Ensure that all transit clips are removed from the refrigerator. These are
■ ■
small rubber stops located at the back of the shelves.
Allow the refrigerator and freezer to run empty for 2 – 3 hours to allow each compartment to
■ ■
cool to the appropriate temperature.
Clean the inside of the appliance with warm water and a little liquid detergent to remove
■ ■
manufacturing and transportation dust.
The appliance may have an odor on its initial operation, but this will go when the refrigerator
■ ■
and freezer have cooled sufficiently.
Energy efficiency
For the most energy efficient use of your appliance:
Ensure your refrigerator has adequate ventilation as recommended in the installation
■ ■
instructions.
Do not cover your appliances with any material that will prevent air from flowing around the
■ ■
cabinet sides.
Allow good clearances in front of the air ducts within the cabinet for maximum cold
■ ■
air distribution.
Cool hot foods down before placing them in the appliance.
■ ■
Do not overfill the compartments.
■ ■
Keep door openings to a minimum.
■ ■
Select a temperature setting that isn't too cold.
■ ■
Check your door seals for leaks.
■ ■