Table of Contents
Advertisement
Turning The System On
TO TURN THE SYSTEM ON IN INSTANT MODE
In INSTANT mode, all alarm sensors including doors that normally have a
delay to allow you to turn the system off will report an alarm immediately
if activated. Check to make sure the system is ready. When it is ready,
press:
INSTANT
When the system has been turned on successfully, the On/Off light and the
Instant light will be on, and the following will display:
LCD Keypad:
ON: INSTANT
PART 1
TO BYPASS A ZONE
The Bypass function excludes a zone of protection from the security system
until it is unbypassed (either by using the unbypass procedure or when you
turn the system off). Bypassing can only be done while the system is turned
off.
Press the BYPASS button. Then enter your user code and the zone number
(1-7) to be bypassed, as follows:
BYPASS
If the Quick Bypass feature has been enabled by the installer, do not
†
enter the user code when bypassing zones.
NOTE: Bypassed zones are NOT protected when the system is turned on.
After the bypass command has been accepted, the keypad sounds one long
beep, and the following will display:
LCD Keypad:
BYPASSED:
FRONT DOOR
TO UNBYPASS A ZONE
Pressing the BYPASS button returns a bypassed zone to normal operation.
To unbypass a zone(s), repeat the bypass function as follows:
BYPASS
After unbypassing, the zone display will show the state of the zones.
followed by your user code.
Fixed-Glass Keypad:
INSTANT
followed by your user code
Fixed-Glass Keypad:
BYPASS
ZN 01
zone number displayed
followed by your user code
(cont)
LED Keypad:
Arm and Instant LED lit
+ ZONE #
†
LED Keypad:
zone
LEDs
zone(s) bypassed slowly
blink
†
+ ZONE #.
of
the
- 13 -
Advertisement
Table of Contents
