Cautions On Disassembly/Assembly Of; Top Chassis; Replacement Of Main Parts; Replacement Of Ccd Unit - Sony DXC-D30WSP Service Manual

CAUTION

2-2-2. Cautions on Disassembly/Assembly of

Top Chassis

When removing the top chassis, following items should be
performed. If not, the connectors (CN503, CN504, CN505)
should be damaged.
Disassembly:
1. Disconnect the two connectors CN504 and CN505 on
the CN-1594 board.
2. Remove the MB-785 board in the holizontal direction.
Because, not to break the connectors.
CN505
MB-785 board
3. Disconnect the connector CN503.
4. Remove the SW-790 board.
Top chassis
Front unit Ass'y
Screws
(B3 x 10: with washer)
2-2
CN504
CN503
CN1594
CN-1594 board
CN-503
Screws
(B3 x 4)
Screws
SW-790 board
(B3 x 4)
Assembly:
1. Insert the partition to the rail of the upper board rail.
Top chassis
Upper board
rail
Partition
2. After assembling the top chassis, assembly the front unit
Ass'y.

2-3. REPLACEMENT OF MAIN PARTS

2-3-1. Replacement of CCD Unit

1. Remove the lens and viewfinder referring to the
instruction manual.
Note: Attach a mount cap to the lens mount to
protect the prism block.
2. Remove the left side plate referring to Section 2-2-1.
"Removal of Side Plate".
3. Remove two screws as shown in Figure.
Remove the AT-125 board. Disconnect the five
connectors CN2, CN105, CN106, CN107 and CN123
on the MB-785 board.
Upper board
rail
Partition
K3 x 6
K3 x 6
DXC-D30WS/P(E)/V1