Reconfigure The Fibre Channel Address; Figure 3-5 Fibre Channel Configuration Menu - HP 2100 ER User Manual

Reconfigure the Fibre Channel Address

Use the Fibre Channel Configuration menu to change from the hard
address mode to the soft address mode.
NOTE The Fibre Bridge default setting is hard addressing, where the address is
preset to 71 (0x82). Use this procedure when an additional bridge is
installed in a system or to resolve a Fibre Channel device ID conflict.
1. From the Configuration menu (Figure 3-4 on page 3-10), select option
2. To toggle between hard addressing and soft addressing, select option
3. To choose a new address, select option 2 and enter a new address from
The "Change ALPA Value" option is not available when the soft address
NOTE
mode has been selected.
Figure 3-5 Fibre Channel Configuration Menu
Chapter 3
2, Fibre Channel Configuration.
1.
the table in Figure 3-6 on page 3-12.
Operating the Fibre Bridge
Making Configuration Changes
3-11