Detaching The Worktop; Door Reversibility - AEG Electrolux S71700TSW0 User Manual

32
Installation

Detaching the worktop

To remove the worktop, please proceed as fol-
lows:
1. Unscrew left and right screws at the front.
2. Unscrew left and right screws at the back.
3. Lift the worktop slightly at the front, push
back about 20 mm and lift off from the
front.
4. Unscrew left and right screws at the back.
5. Store the screws in a safe place together
with the worktop.
Fitting and mounting to continuous worktop
Before fitting, change the door opening direc-
tion if necessary (see: Door reversibility).
Push the appliance carefully into the niche.
Take care that the mains cable is not jammed in.
Check distance from wall (see: Installing under a
continuous worktop).
Level the appliance by screwing the two adjusta-
ble feet at the front in or out, thus ensuring a
stable position.
With a suitable screws (depending on the design
of the worktop and the distance between the appliance and the worktop, not supplied),
fix the appliance under the worktop through the upper door hinge. If necessary, equalise
the gap between the door hinge and the worktop with a suitable washer (plastic or
wood, not supplied). This will prevent bending of the hinge and possible failure of door
function.

Door reversibility

To carry out the following operations, we suggest that this be made with another person
that will keep a firm hold on the doors of the appliance during the operations.
To change the opening direction of the door, do these steps:
1. Remove the plug from the power socket.
2. Tilt back the appliance carefully so that the compressor cannot touch the floor.
3
3
4
1
5
2