Understanding Your Cycles; Automatic Cycle; Timed Cycle(S) - Whirlpool Thin Twin User And Care Manual

Understanding your cycles
See the chart below for descriptions of the cycles that are on your dryer. See page 15 for help
in selecting the right cycle.
NOTES:
l
Use the Energy Preferred Automatic
Setting (+) to dry most loads.
l
Shaded areas in the illustrations show
cycle locations.
l
The last few minutes of all cycles are without
heat to make the load easier to handle.
Automatic cycle
Use an automatic cycle to dry most
loads.
l
The automatic cycle shuts off when your
load reaches the selected dryness.
l
The Cycle Control Knob will not move
until the load is almost dry. After the cool-
down, the Cycle Control Knob autornati-
tally moves to an OFF area and tumbling
stops.
Dry most loads using the Energy
Preferred Automatic Setting b) .
l
If the load is drier than you like, select a
setting closer to LESS DRY the next time
you dry a similar load.
l
If the load is not as dry as you like,
complete drying using a Timed cycle.
Select a setting closer to VERY DRY the
next time you dry a similar load.
NOTE:
Your dryer has high heat and low
heat automatic cycles. Select the cycle to
match your load.
Timed cycle(s)
Use your Timed cycle to complete drying if
some items are damp after automatic
drying. This cycle is also useful for small
loads or large bulky items.
l
For a damp dry, turn the Cycle Control
Knob to 30 minutes or less.
l
To help reduce wrinkling, remove the load
from the dryer as soon as tumbling stops.
This is especially important for permanent
press, knits, and synthetic fabrics.
Ene&
preferred automatic
setting
continued on next page
13