Starting/Stopping Washer; Load Size Selecting; Operating Your Washer; Before Starting Your Washer - Whirlpool Thin Twin User And Care Manual

~~
1
Operating Your Washer
In This Section
Page
Page
Before starting your washer.. ............ .7
Uslng rinse and spin ......................... 10
Starting or stopplng your washer.. ... .7 Using drab and
spln
............... _".. .... 10
Selecting a load size ........................... 7
What happens In each cycle.. ........... 11
Selecting wash-rinse temperatures .. .8 MAGIC CLEAN
l
lint filter.. ................. 11
Selecting a cycle and time .................. 8
Operating your washer properly ensures maximum washing efficiency. This section gives you
important information to help you to select a cycle, time, and temperature for your wash load.
Before starting your washer
Add measured detergent. Then place a
sorted load in the washer before starting.
See page 20 for additional "Before you wash
or dr)r information.
NOTE: lf your washer/dryer has a Con-
sumer Features Guide, remove it and place
it in your Use and Care Guide.
Starting or stopping your washer
Starting your washer:
1. Select load size and water temperatures.
2. Push in the Cycle Control Knob
and
turn it
clockwise. Stop when the indicator on the
knob's outer ring points to the number in
the wash cycle you want. The numbers
are minutes of wash time.
3. Pull out the Cycle Control Knob.
Refer to page 10 for additional informa-
tion to help you make selections.
Stopping and restarting your washer:
l
To stop the washer at any time, push in the
Cycle Control Knob.
l
To restart the washer, close the lid (if
neces-
sary) and pull out the Cycle Control Knob.
Selecting a load size
Position the Load Size Selector at the setting
that corresponds to the size load you want to
wash. Select a load size based upon the size
of the load and the fabric you are washing.
See page 20 for additional loading information.
To change the load size setting after the
washer has started to fill, move the Selector
to the desired new setting.