Lubrication Points - Honda HRC 7013 Owner's Manual

MAINTENANCE & ADJUSTMENTS
Changing the Hydrostatic Oil Filter
1. Drain the reservoir.
2. Remove the oil filter with a filter wrench and let the remaining
oil drain out.
Correctly dispose of the old oil filter.
3. Clean the filter base with a clean cloth.
4. Coat the O-ring of the new filter
with clean oil.
5. Hand tighten the oil filter until
O-ring seats against the filter
base.
6. Tighten the filter by hand an
additional 3/4 - 1 turn.
7. Refill the reservoir with the
correct amount of the
recommended oil.
the
8. Start the engine and allow it to idle for 3 to 5 minutes to
circulate the oil and allow any trapped air to escape.
9. Stop the engine and recheck the oil level.
Lubrication Points
Grease: NGLI #2 Lithium Base EP
Follow the diagrams on the next page to lubricate these
fittings.
l
Caster wheels (2)
0 Caster pivots (2)
0 Pulley pivots (1)
l
Forward speed control shaft (2)
55