Rear Panel Connections And Controls - Extron electronics DVI-RGB 200 User Manual

Rear Panel Connections and Controls

Figure 2.
a
b
c
d
e
100-240V 0.4A DVI-RGB 200
BUFFERED
DVI-DINPUT
LOOP-THROUGH
50/60 Hz
7 1 2 4
DVI-RGB 200 Rear Panel
Input connector — Connect a single link of direct digital video to this 29-pin DVI-I
connector (figure 2) using the included cable.
Buffered Loop-through connector — If desired, connect a direct digital local monitor
to this 29-pin DVI-I connector.
NOTE: The user can also record EDID from a display on the Buffered Loop-Through
connector, store it onto the units internal memory and supply to the source
(DVI-D input). See
Output connectors — Connect an RGB display to these female
BNC connectors.
For RGBHV video — Connect to five BNC connectors as shown at
right. Ensure that the SOG On/Off switch (
For RGBS video — Connect to four BNC connectors as shown at
right. Ensure that the SOG On/Off switch (
For RGsB video — Connect to three BNC connectors as shown at
right. Ensure that the SOG On/Off switch (
EDID Source switch — Set this switch to the Monitor (up) position
to connect the DDC channel between the direct digital video source
and the local monitor.
Set this switch to the Selector (down) position to connect the DDC
channel between the direct digital video source and the built-in
DVI-RGB 200 EDID logic.
EDID Select — If the EDID Source switch (
to the appropriate position to select the desired video resolution. Use the Refresh DIP
switch ( f ) to select the refresh rate. Table 1 identifies the switch positions and the
associated resolutions and vertical refresh rates.
Table 1. Video resolution
EDID Select Refresh
Switch DIP Switch
< >
Pos. Resolution
Dwn Up
0 User EDID See page 6
1 800x600 50 Hz 60
2 1024x768 50 Hz 60
3 1280x720 50 Hz 60
4 1280x768 50 Hz 60
5 1280x800 50 Hz 60
NOTE:
Many monitors will not support all of the resolutions and refresh rates
shown. If you get no display, try a different rate.
R G B
EDID
HIGH EDID
SOURCE
H V S
SELECT
MONITOR
SELECTOR
OUTPUT
LOW
6 5 3
Capturing a User-recorded
f ) is turned off.
f ) is turned off.
f ) is turned on.
d ) is in the Selector position, set this switch
EDID Select Refresh
Switch DIP Switch
<
Pos. Resolution
Dwn
6 1280x1024 50 Hz 60
7 1360x768 50 Hz 60
8 1366x768 50 Hz 60
9 1400x1050 50 Hz 60
A 1440x900 50 Hz 50
B 1600x1200 50 Hz 60
DVI-RGB 200 • Installation and Operation
EDID.
R
H
R
H
R
H
EDID Select Refresh
Switch DIP Switch
> <
Pos. Resolution
Up Dwn
C 1680x1050 50 Hz 60
D 1920x1080 50 Hz 60
E 1920x1200 50 Hz 60
F N/A
G B
V S
G B
V S
G B
V S
>
Up
3