Maintenance - Dimplex BF8000ST Owner's Manual

Operation
Resetting the Temperature
Cutoff Switch
This unit is equipped with a ther-
mostat which controls the tem-
perature of the room by turning
the heater on and off. The heater
is protected with a safety device
to prevent overheating. Should
the heater overheat, an automatic
cut out will turn the heater off and
it will not come back on without

Maintenance

  WARNING: Disconnect power
before attempting any main-
tenance or cleaning to reduce
the risk of fire, electric shock or
damage to persons.
!
NOTE: The fireplace should
not be operated with an accumu-
lation of dust or dirt on or in the
unit, as this can cause a build up
of heat and eventual damage. For
this reason the heater must be
inspected regularly, depending
upon conditions and at least at
yearly intervals.
Light Bulb Replacement
The light bulbs need to be
replaced when you notice a dark
being reset. It can be reset by
switching the Main On/Off Switch
to off and waiting five (5) minutes
before switching the unit back on.
CAUTION: If you need to con-
tinuously reset the heater, un-
plug the unit and call Technical
Support at 1-888-346-7539.
Please have your model and
serial number ready when call-
ing.
section of the flame or when the
clarity and detail of the log Ember
Bed exterior reduces. There are
three bulbs under the Log Set,
which generate the flames and
embers, and two bulbs above the
log that illuminate the log exterior.
Lower Light Bulb Requirements
Quantity of three clear chande-
lier or candelabra bulbs with an
E-12 (small) socket base, 60 Watt
rating. Example: GE 60BC or
Philips 60CTC. Do not exceed
60 Watts per bulb.
Helpful Hints: It is a good
idea to replace all light bulbs at
one time if they are close to the
end of their rated life. Group
11