To Charge The Batteries Using The Off-Board Charger; To Charge Batteries With The Battery Box Removed From The Power Base; To Charge The Batteries Programming Socket Found On The Controller - Pride Z-Chair Owner's Manual

V I . B A T T E R I E S

To charge the batteries using the off-board charger:

1. Position the front of your travel chair next to a standard electrical
outlet. See figure 21.
2. Be certain the controller power is turned off.
3. Plug the off-board charger into the battery box charger port.
NOTE: The off-board charger connector can be inserted
through a slot found on the back of the basket and located di-
rectly in front of the battery box.
4. Plug the off-board charger into the electrical outlet.
NOTE: If it is a Pride off-board charger, then there are two LEDs
in it. Refer to the supplied charger manual for information on
LED indications. If it is not a Pride off-board charger, then follow
the instructions supplied by the manufacturer.
5. When the batteries are fully charged, disconnect the off-board
charger from the electrical outlet and then from the battery box.
NOTE: The Z-Chair batteries can be charged when the battery
box is removed from the power base.
To charge the batteries with the battery box removed from the
power base:
1. Remove the battery box from the power base. See IV. "Assem-
bly/Disassembly.".
2. Position the battery box next to a standard electrical outlet. See
figure 22.
3. Plug the off-board charger into the battery box charger port.
4. Plug the off-board charger into the electrical outlet.
5. When the batteries are fully charged, unplug the off-board charger
from the electrical outlet and then from the battery box.
6. Reinstall the battery box to the power base.
To charge the batteries using the off-board charger /program-
ming socket found on the controller:
1. Position the front of your travel chair next to a standard electrical
outlet.
2. Be certain the controller power is turned off and the freewheel
levers are in the engaged position. See III. "Your Z-Chair."
3. Plug the off-board charger into the off-board charger/program-
ming socket located on the controller. See figure 23.
4. Plug the off-board charger into the electrical outlet.
5. When the batteries are fully charged, unplug the off-board charger
from the electrical outlet and then from the controller.
26
A N D
www.pridemobility.com
C H A R G I N G
Figure 21. Battery Charging
Figure 22. Battery Charging (Battery Box
Removed)
Figure 23. Battery Charging through the
Controller
Z-Chair