Installing The Hp Lan Card - HP 10BT NightDIRECTOR/100 Installation Manual

1 Installing the HP LAN Card

Installing the HP LAN Card
Installing the HP LAN Card
For complete information on how to install an accessory card (or
board), refer to your PC User's Guide. The following steps are given as
a guide.
1 With the PC turned off, disconnect the power cord and any
connection to a telecommunications network, and then remove the
cover.
2 Depending on the PC model, you may need to remove the accessory
slot's retaining bracket, which can be found at the back of the PC.
3 Remove the slot cover.
4 Connect the External Start cable and, without bending it, insert the
card into the accessory slot.
5 Secure the card by replacing the slot cover screw or the retaining
bracket and its screw, as appropriate for the PC.
6 Replace the cover. Reconnect the power cord and any connection to
a telecommunications network.
8 English
The card may be installed in a minitower
model or in a desktop model.
Refer to "HP LAN Card Specifications"
on page 14 for the position of the
External Start connector on the HP LAN
card. Refer to the PC's user or technical
documentation for the position of the
External Start connector on the system
board.
16