Pre-Installation Procedure; Pre-Installation On A Windows 95 System; Pre-Installation On A Windows Nt 4.0 System - HP 10BT NightDIRECTOR/100 Installation Manual

1 Installing the HP LAN Card

Pre-installation Procedure

Pre-installation Procedure
CAUTION Perform the pre-installation before you physically install the HP LAN
card in the PC.

Pre-installation on a Windows 95 System

1 With Windows 95 running, insert the HP LAN Setup diskette into the
2 Click Start, and then Run.... The Run dialog box opens.
3 In the command line, type a:\setup and click OK. A network
4 Click Next. A second network setup dialog box opens.
5 Click Finish. The PC reboots under DOS and displays a message
6 Type n, then remove the HP LAN Setup diskette from the diskette
7 Now go to "Installing the HP LAN Card" on page 8.

Pre-installation on a Windows NT 4.0 System

1 With Windows NT running, insert the HP LAN Setup diskette into
2 Click Start, then Run....
3 In the command line, type a:\setup and click OK. An account
4 Enter the name of an account which is a member of the
5 Click Next. A dialog box is displayed.
6 English
diskette drive.
setup dialog box opens.
asking you whether there is another LAN card already installed.
drive and turn off the PC.
the diskette drive.
information dialog box opens.
administrator group, and the corresponding password. If you are
already logged on with administrator's rights, the field for the
account name is automatically filled in with your account name.
14