Advertisement
2
Power off the library.
Use your backup software to verify that the
a.
picker is empty, or to empty the picker.
Press the power button located on the front
b.
of the library and wait until the OCP goes
blank.
4
Flip the two breaker switches off (to the left) at the
power distribution unit.
6
Hold the ejector handles so they extend toward
the outer edges of the controller.
3
Open the back door of the library.
Controller Installation
5
Using a #1 Phillips screwdriver, remove the blank
plate from the next available of the top six slots in
the card cage.
7
With the FC ports located to your right as you face
the back of the library, slide the controller into the
card cage slot. Tighten the ejector handle screws.
Advertisement
