Major Components - MULTIQUIP EM-70S Operation Manual

EM-70 PLASTER/MORTAR MIXER — MAJOR COMPONENTS
7
4
3
2
6
5
1
19
Figure 5. Mixer Components
Figure 5 illustrates the basic components and controls of
the MQ Essick EM-70 mixer
1. Tires Ply -The tire ply (layers) number is rated in letters;
This mixer uses 13-inch 4-ply tires.
2. Engine Cover -Lift this cover to gain access to the
engine compartment.
3. Belt Slip Lever -When starting this lever should be
move upward and to the left. For mixing place the lever
in the down position. See attached decal located
adjacent to lever.
4. ON/OFF Switch (electric) -This switch is provided on
mixers with electric motors. To gain access to this switch,
lift the engine cover. When activated it will shut down
the electric motor.
5. ON/OFF Switch (gasoline) -This switch is provided
on mixers with gasoline engines only and is located
on the side of the engine cover. When activated it will
shut down the engine.
6. Latch -Use this latch to secure the engine compartment
cabinet.
7. Drum Bearing -There is on each end of the mixing
drum, a sealed bearing. Bearings are packed and sealed
at the factory and require no further maintenance.
8. Mixing Paddles -Used in the mixing of material. This
unit uses four different types of paddles to provide a
fast uniform mix.
PAGE 16 — EM-70 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (008/10/04)
9 10
8
11
12
13
15
14
18
17
9. Bag Cutter-This feature allows compound mixing bags
to be opened easily, therefore allowing the contents of
the bag to fall directly into the mixing drum.
10. Safety Grill -Provided for operator safety. This safety
grill is designed to keep hands and solid objects out of
the mixing drum when in use. This grill should be closed
at all times when mixer is in use. DO NOT remove the
grill or grill opening bar. Keep the grill clean by washing
it down daily.
16
11. Dump Handle -Pull this handle downward to dump the
contents of the drum. Push the handle upward to return
the drum to its vertical position.
12. Safety Grill Lock Handle -To prevent injury to hands
and arms, the safety grill should ALWAYS be locked
when the mixing of plaster or mortar is required. Also
when transporting the mixer the safety grill should be
locked. The safety grill should only be un-locked when
cleaning of the blades and drum is required.
13. Pivot Point/Zerk Fitting -There is, on each end of the
mixing drum a zerk grease fitting. These fittings lubricate
the dumping mechanism. Lubricate both fittings at least
twice a week.
14. Dump Handle Release Pin -Pull this pin outward (spring
loaded) to release the drum, then pull down on the dump
handle to place the drum in the dump position. When
drum is in dump position, pin will automatically lock
drum.
15. Mixing Drum -Mixing materials such as mortar, plaster
are to be placed into this drum for mixing. Always clean
the drum after each use.
16. Tow Bar/Coupler -This mixer uses a 2-inch coupler or
pintle towbar.
17. Safety Chain -This mixer uses a 3/16-inch thick, 72-
inches long zinc-plated saftey chain. ALWAYS connect
the safety chain when towing.
18. Forklift Pockets – When lifting of the mixer is required,
use these fork lift pockets to lift the mixer. Remember to
insert the forks of the forklift a minimum of 24 inches
into the lift pockets.
19. Chock Blocks - Place these blocks (not included as
part of the mixer package) under each mixer wheel to
prevent rolling.