Rules For Safe Operation - MULTIQUIP EM-70S Operation Manual

EM-70 PLASTER/MORTAR MIXER — RULES FOR SAFE OPERATION
■ ALWAYS stop the engine before servicing, adding fuel
and oil.
■ NEVER run engine without air filter. Severe engine may
occur.
■ ALWAYS service air cleaner frequently to prevent
carburetor malfunction.
■ ALWAYS be sure the operator is familiar with proper safety
precautions and operations techniques before using mixer.
■ ALWAYS store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children.
■ DO NOT operate this equipment unless all guards and
safety devices are attached and in place.
■ CAUTION must be exercised while servicing this
equipment. Rotating and moving parts can cause injury
if contacted.
■ When towing, an adequate safety chain must be fastened
to the frame. See Towing Guidelines section in this manual.
■ Keep all inexperienced and unauthorized people away
from the equipment at all times.
■ Unauthorized equipment modifications will void all
warranties.
■ Check all fasteners periodically for tightness. Also check
towing tongue bolt, lock nut and wheel lug nuts for wear.
■ Stop the engine and disconnect the spark plug before
allowing anybody's hands in the mixing drum.
■ NEVER pour or spray water over the engine or electric
motor.
WARNING WARNING WARNING
WARNING WARNING
Always stand clear of the dump handle when the mixer
is in operation. Any binding of material between the mixer
blades and the drum will cause the drum handle to quickly
move and could cause bodily harm.
■ Depending on type of mixer, test the ON/OFF switch for
either the gasoline engine or electric motor before operating.
The purpose of these switches is to shut down the engine
or motor of the mixer.
■ Refer to the HONDA Engine Owner's Manual for engine
technical questions or information recommended by
Multiquip for this equipment. Damage to the equipment
and/or injury to user may result.
EM-70 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (008/10/04) — PAGE 11
Stand Clear of the
Mixer when in use
TRANSPORTING
■ ALWAYS shutdown engine before transporting.
■ Tighten fuel tank cap securely and close fuel cock to
prevent fuel from spilling.
■ Drain fuel when transporting mixer over long distances
or bad roads.
MAINTENANCE
■ NEVER lubricate components or attempt service on a
running mixer.
■ ALWAYS allow the mixer a proper amount of time to
cool before servicing.
■ Keep the mixer in proper running condition.
■ Fix damage to the mixer immediately and always replace
broken parts.
■ Dispose of hazardous waste properly. Examples of
potentially hazardous waste are used motor oil, fuel and
fuel filters.
■ DO NOT use food or plastic containers to dispose of
hazardous waste.
EMERGENCIES
■ ALWAYS know the location of the nearest fire
extinguisher and first aid kit.
■ In emergencies always know the location of the
nearest phone or keep a phone on the job site .
Also know the phone numbers of the nearest
ambulance , doctor and fire department . This
information will be invaluable in the case of an
emergency.