Table of Contents
Advertisement
H8DCR-3/H8DCR-i User's Manual
Wake-On-LAN
The Wake-On-LAN header is desig-
nated JWOL. See the table on the
right for pin defi nitions. You must
have a LAN card with a Wake-On-LAN
connector and cable to use the Wake-
On-LAN feature.
(*Note: Wake-On-LAN from S3, S4,
S5 are supported by LAN1. LAN2 sup-
ports Wake-On-LAN from S1 only.)
Wake-On-Ring
The Wake-On-Ring header is desig-
nated JWOR. This function allows
your computer to receive and "wake-
up" by an incoming call to the modem
when in suspend state. See the table
on the right for pin defi nitions. You
must have a Wake-On-Ring card and
cable to use this feature.
SMBus Header
The header at J22 is for the System
Management Bus. Connect the ap-
propriate cable here to utilize SMB on
the system. See the table on the right
for pin defi nitions.
Alarm Reset Header
Connect JAR to the alarm reset but-
ton on your chassis (if available) or to
a microswitch to allow you to turn off
the alarm that sounds when a power
supply module fails. See the table on
the right for pin defi nitions.
Wake-On-LAN
Pin Defi nitions
Pin#
1
2
3
Wake-On-Ring
Pin Defi nitions
Pin#
1
2
SMBus Header
Pin Defi nitions (J22)
Pin#
1
2
3
4
Alarm Reset Header
Pin Defi nitions (JAR)
Pin#
1
2
2-14
(JWOL)
Defi nition
+5V Standby
Ground
Wake-up
(JWOR)
Defi nition
Ground (Black)
Wake-up
Defi nition
Data
Ground
Clock
No Connection
Defi nition
Ground
Reset Signal
Advertisement
Table of Contents
