TP-Link TL-WA730RE User Manual page 32

Universal Repeater - In Repeater mode, the AP with WDS enabled will relays data to
an associated root AP. AP function is enabled meanwhile. The wireless repeater relays
signal between its stations and the root AP for greater wireless range.
WDS Repeater - In Universal Repeater mode, the AP with WDS disabled will relays
data to an associated root AP. AP function is enabled meanwhile. The wireless
repeater relays signal between its stations and the root AP for greater wireless range.
Wireless Name of Root AP - If you select the radio button before Wireless Name of Root
AP, the AP client will connect to the AP according to SSID. Enter the SSID of AP that you
want to access.
MAC Address of Root AP - If you select the radio button before MAC Address of Root AP,
the AP client will connect to the AP according MAC address. Enter the MAC address of AP
that you want to access.
Region – Please select the right region from the drop-down list.
Channel Width - Determines the channel width to be used. It is unnecessary to change the
default value unless required.
Enable Wireless Radio - Select or deselect this check box to allow or deny wireless stations
to access the device.
Click the Survey button to detect the SSIDs in the local area.
Note:
To apply any settings you have altered on the page, please click the Save button, and then you
will be reminded to reboot the device.
2) Access Point: This mode allows wireless stations to access this device.
SSID (Set Service Identifier) - Identifies your wireless network name. Create a name up to 32
characters and make sure all wireless points in the wireless network with the same SSID. The
default SSID is TP-LINK_XXXXXX (XXXXXX indicates the last unique six characters of each
device's MAC address). This value is case-sensitive. For example, TEST is NOT the same as
test.
TL-WA730RE 150Mbps Wireless N Range Extender User Guide
Figure 4-12 Wireless Settings in Access Point mode
24