Removing Or Replacing The Service Door; Removing The Service Door; Replacing The Service Door - HP Computer User Manual

Removing or replacing the service door

Removing the service door

Remove the service door to access the memory module slots, hard drive, and other components.
1. Remove the battery (see
2. With the battery bay toward you, slide the service door release latch (1) to the left, remove the
screw (if the optional screw is being used) (2), and then slide the release latch again (3) to
release the service door.
3. Slide the service door toward the front of the computer (4) and lift to remove the service door (5).

Replacing the service door

NOTE: If you do not want to use the optional screw, you can store it inside the service door.
Replace the service door after accessing the memory module slots, hard drive, and other
components.
1. Tilt down the service door (1) to align the front edge of the service door near the front edge of
the computer.
2. Insert the alignment tabs on the rear edge of the service door with the notches on the computer.
3. Slide the service door (2) toward the battery bay until the service door snaps into place.
Inserting or removing the battery on page 34).
Using hard drives 45