Husqvarna Rider 13 Workshop Manual page 50

Reparation instructions
2
Adjusting Rider 11 Bio and Rider 13 Bio
• Remove the front cover and the right-hand
fender.
• Unscrew the nut (1) on the parallel strut. Remove
the locking clips (3) and the parallel strut (2).
• Turn the fork anticlockwise to raise the cover's
rear edge, clockwise to lower the cover's rear
edge.
• Once adjustment is complete, refit the parallel
strut and clip and tighten the nut.
• Recheck the alignment of the cutting unit after
adjustment.
• Refit the right-hand fender and hood.
48
– English
2
Adjusting Rider 16
• Remove the front cover and the right-hand
fender.
• Loosen the nuts on the parallel strut.
• Screw in (shorten) the strut to lower the rear
edge of the cover.
Screw out (extend) the strut to raise the rear
edge of the cover.
• Tighten the nuts after adjustment.
• On completion of the adjustment the unit's
parallelism should be re-checked.
• Fit the right-hand fender and the front hood.