Oven Door And Glass Panels - Electrolux EOD3410A User Manual

18 www.electrolux.com
2. Hold the heating element with the two
hands at the front
3. Pull it forwards against the spring
pressure and out along the support
on both sides.
4. The heating element folds down.
The oven ceiling is ready to clean.
Installing the heating element
1. Install the heating element in opposite
sequence.
Removing the door and the glass panels
B
A
A
Install the heating element cor-
rectly on the two sides above the
support on the inner wall of the
oven.
2. Insert shelf support rails.

9.3 Oven door and glass panels

You can remove the oven door and the
internal glass panels to clean them. The
number of glass panels is different for dif-
ferent models.
CAUTION!
Be careful when you remove the
door from the appliance. The door
is heavy.
1. Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two
door hinges fully.
3. Close the oven door until the first po-
sition (angle approx. 45°).
4. Hold the oven door with one hand on
each side and pull it away from the
oven at an up angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
This is to prevent scratches.
6. Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
7.
Pull the door trim to the front to re-
move it.