Honeywell OMNI-408 User Manual page 5

The following table lists the "Quick Commands" available with this control
Keystroke Quick Command
1
#
Quick Arm
Force Arm
2
#
[BYPASS] + Quick Bypass
Zone No.
Set Time
3
#
Zone Directory
4
#
Display Firmware Version
55
#
Display Keyfob Battery Status
56
#
Change/View Pager Number
58
#
Display/Toggle Chime Mode
6
#
Display Current Time
7
#
User Page Toggle
8
#
Quick Reference (cont'd)
Keypads Description
If system is ready, allows you to arm the system without
All keypads
requiring your User Code. Your User Code is always
needed to disarm the system.
All keypads Allows you to arm the system even if some zones are
faulted. These zones are automatically bypassed and are
unprotected.
All keypads Allows you to bypass a specific zone number. Must be
enabled by your installer.
All keypads Allows entry of the current system time (hours, minutes,
month, day, year).
LCD only Displays listing of zones in system.
LCD only Displays version of your OMNI-408 firmware.
All keypads Allows you to test battery status of your keyfob. Upon
entry of this mode, press any button on the keyfob and the
keypad will display if your battery is low.
All keypads Allows you to redirect pager output to a different pager
number. Phone numbers are displayed only on LCD
keypads.
All keypads Allows you to change the status of the chime function.
LCD only Allows you to view the current system time.
All keypads Allows you to turn the pager mode on or off. Keypad
displays the current system status.
.
– 5 –