Powering Off And Restarting; Port Id Numbering - ATEN Master View CS-1762 User Manual

CS-1762 / CS-1764 User Manual

Powering Off and Restarting

If it becomes necessary to Power Off the Master View unit, before starting it back up
you must do the following:
1. Shut down all the computers that are attached to the switch.
2. Unplug the switch's power adapter cable.
3. Wait 10 seconds, then plug the switch's power adapter cable back in.
4. After the switch is up, Power On the computers.

Port ID Numbering

Each CPU port on the CS-1762 / CS-1764 switch is assigned a port number (1 or 2 for
the CS-1762; 1 to 4 for the CS-1764). The port numbers are marked on the rear panel of
the switch (see p. 6).
The Port ID of a computer is derived from the CPU port number it is connected to. For
example, a computer connected to CPU port 2 has a Port ID of 2.
The Port ID is used to specify which computer gets the KVM USB peripheral, and audio
focus with the Hotkey port selection method (see Going Directly to a Port, p. 14, for
details).
12
2004-06-04