Valve Service And Replacement - Heat & Glo Dakota 42-B Owner's Manual

A. Valve Service and Replacement
Tools Required
Phillips sc
rewdriver
/8 in., 13/16 in., 15/16 in. wrenches
7/16 in., 5
Figure 12.1 Tools Required
• The valve can be accessed through the valve access panel
on the right side of the fi replace.
• Lift doors out and set aside.
• Remove grate and pilot shield (see Figure 6.2).
Figure 12.2 Lift Out Doors
• Use a phillips screwdriver to remove the right refractory by
removing the two screws securing the refractory retaining
strip. Remove the refractory side panel and set aside.
Figure 12.3 Loosen Refractory Retaining Strip
24 Heat & Glo LifeStyle Collection • Dakota 42-B/Dakota 42H-B • 4036-909 Rev D • 08/06
• Remove the inside valve access panel by lifting it up and
out.
Figure 12.4 Remove Valve Access Panel
• Using a phillips screwdriver remove the exterior valve
access panel.
Figure 12.5 Remove Exterior Valve Access Panel
• Turn the gas ball valve off and disconnect the gas line after
the ball valve by loosening the fl are nut using a 13/16 in.
and a 15/16 in. wrench.
Figure 12.6 Turn off Gas Valve