Table of Contents
Advertisement
2 2
Getting Started
A. Design and Installation Considerations
Note: This appliance must be installed outside.
CAUTION
Check building codes prior to installation.
•
Installation MUST comply with local, regional,
state and national codes and regulations.
•
Consult insurance carrier, local building, fire
offi cials or authorities having jurisdiction about
restrictions, installation inspection, and permits.
When planning an appliance installation, it's necessary to
determine the following information before installing:
•
Where the appliance is to be installed.
•
Gas supply piping.
•
Electrical wiring.
•
Framing and fi nishing details.
Moisture Resistance:
This outdoor fi replace will shed moderate amounts of water,
but is not waterproof. Water and condensing water vapor
may enter the chase under certain conditions.
The fi replace will not perform as an exterior wall. Moisture
penetration must be considered for construction that places
the fi replace in structure walls or on moisture sensitive sur-
faces.
When installed on exterior walls: Hearth & Home Tech-
nologies recommends that the fi replace chase be con-
structed outside the structure's weather envelope. Where
the platform meets the wall, use a fl ashing detail similar to
that required for attached decks. Chase platforms, including
hearths should slope away from the structure at 1/8 in. to
1/4 in. per foot. The fi replace can be shimmed level.
When installed on surfaces where water may collect or
cause damage: Hearth & Home Technologies recommends
that a drainage pan be placed under the unit. This can be
constructed of metal, adhesive polymer membrane (such as
ice and water shield) or other suitable materials. A means of
drainage out of the pan such as tubes or weep holes should
be provided. A slope of 1/8 in. to 1/4 in. per foot towards
the drain port is suggested. The fi replace can be shimmed
level.
Hearths should slope away from the front of the fi replace
and chase at 1/8 in. to 1/4 in. per foot. Spark strips must be
on top of any combustible hearth materials used for moisture
management.
Heat & Glo LifeStyle Collection • Dakota 42-B/Dakota 42H-B • 4036-909 Rev D • 08/06
B. Tools and Supplies Needed
Before beginning the installation be sure that the following
tools and building supplies are available.
Reciprocating saw
Pliers
Hammer
Phillips screwdriver
Flat blade screwdriver
Plumb line
Manometer
Tape measure
Non-corrosive leak check solution
1/2 - 3/4 inch length, #6 or #8 Self-drilling screws
C. Inspect Appliance and Components
WARNING
Inspect appliance and components for
damage. Damaged parts may impair safe
operation.
•
Do NOT install damaged components.
•
Do NOT install incomplete components.
•
Do NOT install substitute components.
Report damaged parts to dealer.
•
Carefully remove the appliance and components from the
packaging.
•
The gas logs may be packaged separately and must be
fi eld installed.
•
Report to your dealer any parts damaged in shipment,
particularly the condition of the glass.
•
Read all of the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety and
benefi t.
WARNING
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
•
Installation and use of any damaged appliance or
vent system component.
•
Modifi cation of the appliance or vent system.
•
Installation other than as instructed by Hearth & Home
Technologies.
•
Improper positioning of the gas logs or the glass
door.
•
Installation and/or use of any component part not
approved by Hearth & Home Technologies.
Any such action may cause a fi re hazard.
Framing material
Hi temp caulking material
Gloves
Framing square
Electric drill and bits (1/4 in.)
Safety glasses
Voltmeter
Level
5
Advertisement
Table of Contents
