SOYO SY-7ISA Quick Start Manual page 11

CPU Frequency Settings: JP6, JP7, CJ1 and CJ2
Step 9.
For certain Intel CPUs, the multiplier is not locked such that setting a multiplier higher than
specified on the CPU is possible. For technical details read the following:
Your FC-PGA 133/100/66 MHz FSB CPU has a pin JP6, JP7 to tell it what FSB frequency
the CPU requires; If these two jumpers are shorted the motherboard will automatically run at
the frequency the CPU was specified to run at.
However, the FSB Frequency can also be set through jumpers CJ1 and CJ2 and it may
therefore differ from the Frequency the CPU specifies. If CJ1 and CJ2 are to be used, JP6 &
JP7 must be open. Doing so may however force your CPU to operate out of its
specifications and therefore SOYO can not guarantee the proper functioning of your system.
Refer to the following table:
CPU Frequency
Automatic
66MHz
100MHz
Manual
133MHz
CMOS Clear (JP5)
In some cases the CMOS memory may contain wrong data, follow the steps below to clear
CMOS memory.
1. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. This jumper
can be easily identified by its white colored cap.
2. Then put the jumper back to 1-2 to allow writing new of data into the CMOS memory.
CMOS Clearing
Short pin 2-3 for
JP5 Setting
at least 5 seconds to
clear the CMOS
Note: You must unplug the ATX power cable from the ATX power connector when
performing the CMOS Clear operation.
JP6 JP7
Short Short
1 2
Open
Open
1 2
Open Open
1 2
Open Open
1 2
Clear CMOS Data
1 2 3
11
SY-7ISA Quick Start Guide
CJ1
Open Open
1 2 3
1 2
2-3 2-3
1 2 1 2 3
1-2 2-3
1 2
1 2 3
1-2 1-2
1 2 3
1 2
Retain CMOS Data
Short pin 1-2 to
retain new
settings
1 2 3
CJ2
1 2 3
1 2 3
1 2 3
1 2 3