Table of Contents
Advertisement
Programming a memory position
Note: You can program a memory position at any time.
• To program position 1, move the memory features to the desired
positions using the associated controls. Press and hold button 1 for at
least two seconds. A chime will sound confirming that a memory
position has been set.
• To program position 2 and 3, repeat the previous procedure using the
respective buttons.
Recalling a memory position
You can recall a programmed memory position:
• in any gearshift position if the ignition is not on.
• only in position P or N if the ignition is on.
Press the desired memory control to recall a memory position.
Recalling memory positions with the remote control
You can recall memory positions when you press unlock on your remote
control (if the transmitter is programmed to a memory position) or,
when you enter a valid personal entry code that is programmed to a
memory position. If the easy entry feature is enabled, the seat will first
move to the easy entry position. The seat will move to the final position
when the key is in the ignition or when the push button start system
(if equipped) is put in accessory mode or started.
To program the memory feature to a remote control, see the Keys and
Remote Control chapter.
Easy Entry and Exit Feature
This feature can move the seat rearward and the steering column up and
forward to allow extra room to exit the vehicle.
This occurs when:
• you place the transmission selector lever in position N or P, and
• you turn the ignition off.
The seat and steering wheel will move to their original positions when:
• the transmission selector lever is in position N or P, and
• the ignition is turned on
Turn the Easy Entry/Exit feature on or off through the information
display settings menu. See the Information Displays chapter.
2014 MKT (mkt)
Owners Guide gf, 2nd Printing, December 2013
USA (fus)
Seats
149
Advertisement
Table of Contents
