Tools And Materials Required; Electrical Outlet Box - Hunter Piccolo Owner's Manual

Unpacking the Fan
1. Unpack your fan and check the contents. Do not discard the box. If warranty replacement or repair
is ever necessary, the fan should be returned in its original packaging. Remove all parts and hard-
ware. Do not lay the motor housing on its side; the decorative casing may shift.
2. Examine all parts. You should have the following:
1. Mounting Bracket
2. Motor
3. Motor Housing
4. Blade Irons
5. Blades
6. Parts Pack Containing:
a. Mounting bracket hardware (extra screw
and washer, wire nuts, extra motor screw,
and washer)
b. Noise isolators, blade nuts, blade screws
Note: Some Revolutions fan models will have slightly different parts than shown here,
depending upon the model. Basic installation procedures are similar for all fan models.

Tools and Materials Required

• Phillips screw driver
• Flat Head screw driver
• Adjustable pliers or wrench
• Step Ladder
• Wire Cutter
• Electrical tape

Electrical Outlet Box

1. If there is an existing outlet box, ensure it is NOM listed and clearly marked 'Suitable for Fan Support" If not, it must
be replaced with an approved one.
2. Secure the outlet box (or make sure the existing box is secured) directly to the building structure. Use appropriate
fasteners and building materials. Wood joist and outlet box must be able to support a minimum of 50 pounds.
3. Figures 1, 2, and 3 are examples of different ways to mount the outlet box in different situations. A longer downrod
may be required in sloped ceiling situations to maintain proper blade clearance.
4. To hang the fan in locations where no ceiling joist is available, a hanger support bar may be required(Fig.4).
3
ME003-01 06/04/2014
1 4
2 5
3 6