Honda BF75D Owner's Manual page 118

TAKING CARE OF UNEXPECTED PROBLEMS
FUSE PULLER
4. Use the fuse puller from the tool kit
to remove the fuses. If a fuse is
blown, install a replacement fuse of
the same specified rating. The
outboard motor is supplied with
spare fuses in the fuse holder.
MAIN FUSE RATINGS: 
10 A, 15 A, 30 A
5. Reinstall the fuse case lid,
electrical parts cover, and the
engine cover.
116
6. Reconnect the battery.
Never use a fuse with a rating greater
than specified. Serious damage to the
electrical system could result.
If a blown fuse is found, try to
determine and correct the electrical
problem that caused the blown fuse.
An uncorrected electrical problem
may cause the fuse to blow again.
If fuses continue to blow, take the
outboard motor to an authorized
Honda Marine dealer for inspection
and service, or refer to the shop
manual.
ACG Fuse
''70 A'' MARK SPARE FUSE (70 A)
3 mm SCREWS
ACG FUSE (70 A)
FUSE CASE LID
1. Stop the engine and disconnect the
battery cable.
2. Remove the engine cover.
3. Remove the fuse case lid.