iHome iBT28 Quick Start Manual page 9

Different regions of the world use different FM radio frequency steps and ranges. You will need to select the one that matches
the standards in your region (USA, EUROPE, JAPAN, AUSTRALIA, or CHINA). The default setting is USA; if you live in the US,
you may skip this section.
1. Make sure the unit is OFF (not playing in any mode). Press and hold the + AND – Button together for about 5 seconds
until "USA" appears in the lower part of the display and 1 beep sounds. Press and release the + or – Button to set to
your region.
2. Allow unit to "time out" (no button pressed within 5 seconds) to exit the radio frequency setting mode.
Two beeps will confirm radio frequency setting.
1. Connect the included stereo audio cable to the Aux-in jack located on the back of the unit and connect the other end to
the headphone jack or aux-out jack on your audio device.
2. Press and release the
3. Press and release the Pairing/ Mode Button as needed to cycle to Aux-in mode. "Aux in" will appear on the display.
4. Control audio playback and navigate tracks and menus from your audio device.
Button to adjust the unit volume. You may need to adjust the volume on your device, too.
5. Press the or
6. To turn off the unit, press and release the
A USB port is located on the back of the unit for charging devices while the unit is connected to AC power.
Connect one end of a compatible USB cable (not included) into the standard USB port on the unit and the other end into the
device you wish to charge. Some devices require proprietary USB charging ports or cables. Monitor the charging status of
your device. If the device does not charge, you will need to use the charger that came with your device.
Using the Unit in Other Countries
Playing your Aux-in Audio Device
Button to turn on the unit. Turn on your aux audio device, too.
Button. Make sure to turn off your audio device, too.
Charging a Device with the USB Port
6